Hot and Cold Pressure Test
We isolate and charge both supply sides with a pressure testing gauge and watch for a drop. This tells us which line is losing water and rules out fixtures, the water heater, and irrigation before we focus on the slab.
Every detection visit includes the full diagnostic sequence, not just a listen-and-leave. We isolate the system, test both hot and cold sides, scan the slab, and confirm the location before we quote a repair. If the leak turns out to be outside the slab, we tell you that too and point you to the right service.
We isolate and charge both supply sides with a pressure testing gauge and watch for a drop. This tells us which line is losing water and rules out fixtures, the water heater, and irrigation before we focus on the slab.
An acoustic listening disc and a FLIR thermal imaging camera cover the suspect area. We mark the readings on the floor so you can see where the sound and temperature anomalies line up.
A moisture meter and, where accessible, a pipe inspection camera or tracer gas detector confirm the break. We do not quote a repair off a single reading; the location is verified before we mark it.
We mark the break on the floor, photograph it, and give you a written finding with the cause and the recommended repair. That document is useful for insurance and for any second opinion you want to get.
You get a price for the repair before any concrete is cut, including the patch and the pressure test afterward. If epoxy pipe lining fits the line, we quote that option alongside a spot repair.
Under Slab Leak Detection in Fort Pierce is the process of locating a pressurized water or drain line failure beneath a concrete floor without tearing up the slab to find it. We start by isolating the system with a pressure testing gauge, then listen through the concrete with an acoustic listening disc and scan the floor surface with a thermal imaging camera. A hot water line leak shows up as a warm patch; a cold line shows as a pressure drop that will not hold. The goal is simple: mark the break within a few inches so the repair is a small, targeted cut instead of a room-wide demolition.
Fort Pierce homes sit on some of the most variable soil in St. Lucie County, and that is where most of these leaks begin. Shifting sand and shell hash move copper pipe until a fitting cracks or a pinhole opens, and the slab hides the evidence until the water bill doubles. If you have been searching for under slab leak detection near me Fort Pierce FL and getting nothing but guesses, we can pressure-test the system and tell you which line is losing water in about an hour. That is the difference between a repair and a remodel.
Every call follows the same sequence, whether it is a hot water line under a Lakewood Park ranch or a commercial slab on US-1. You get a clear answer on where the leak is and what the repair involves before we cut anything.
Schedule
Call or book online — a real human picks up and confirms a 2-hour arrival window.
Diagnose
Licensed tech inspects on-site, then walks you through the cause and your options.
Fix
The job is completed to code and done right the first time — no shortcuts, no surprises.
Guarantee
Every job backed by a written workmanship warranty — and we stand behind it.
Acoustic Listening Disc
Amplifies the sound of water escaping a pressurized pipe so we can narrow the break to a small area through concrete, tile, or vinyl flooring.
FLIR Thermal Imaging Camera
Maps temperature differences across the slab. A hot water line leak shows as a warm plume, and a cold line often shows as a cool spot.
Pressure Testing Gauge
Isolates and charges the hot and cold sides to confirm which line is losing water before we scan the slab.
Electronic Leak Detection Wand
Picks up the high-frequency sound of a pinhole or crack and helps confirm the acoustic disc reading in noisy environments.
Tracer Gas Detector
Introduces a safe tracer gas into the line and detects where it escapes, which is useful when acoustic readings are ambiguous.
Pipe Inspection Camera
Confirms the line material and the break location from inside the pipe where access allows, including copper, PEX, and CPVC.
Moisture Meter and Infrared Thermometer
Confirms the wet reading at the marked spot and verifies the temperature anomaly before any concrete is cut.
System Isolation and Pressure Testing
We shut off the supply, isolate the hot and cold sides, and charge each with a pressure testing gauge. A drop on one side tells us which line is failing and rules out fixtures, irrigation, and the water heater before we focus on the slab.
Acoustic and Thermal Correlation
We combine the acoustic listening disc with the FLIR thermal camera and look for where the sound and temperature readings agree. Correlating two methods is how we avoid marking a spot based on a single ambiguous reading.
Tracer Gas Confirmation
When acoustic and thermal readings are close but not conclusive, we introduce a safe tracer gas into the isolated line and detect where it escapes. This is common on deeper slabs and under tile where sound transmission is poor.
Epoxy Pipe Lining Evaluation
For copper lines with multiple pinholes, we evaluate whether epoxy pipe lining is a fit before recommending a spot repair. Lining can restore the line from the inside and avoid repeated cuts in the same slab.
01
What we do: We isolate the hot and cold sides, pressure-test both, and run an acoustic scan across the tile. Copper pinholes in older Fort Pierce homes are common, and the disc usually narrows the location within an hour.
→ The break is marked, the repair is quoted, and the homeowner avoids a full-floor demolition.
02
What we do: A thermal imaging camera maps the warm plume and a moisture meter confirms the reading. We mark the spot and check the manifold to rule out a fitting failure at the source.
→ The hot water line leak is located to within a few inches and repaired with a small cut and patch.
03
What we do: We pressure-test the system, listen with the acoustic disc, and confirm the line with a pipe inspection camera where accessible. The property manager gets a written finding for the owner.
→ The leak is located and repaired, and the owner has documentation for the insurance file.
04
What we do: We isolate the domestic supply from the irrigation and fire lines, then scan the slab with thermal and acoustic tools. Commercial slabs often hide the break under tile or carpet, and the camera confirms the line.
→ The break is pinpointed after hours, and the repair is scheduled without closing the business.
Fort Pierce sits on sandy, shelly soil that moves with the water table, and that movement is hard on copper pipe. Homes built before the 1980s near Downtown Fort Pierce and Lincoln Park usually have copper supply lines that develop pinholes where the soil shifts, while newer builds in Fort Pierce South and White City often use PEX tubing with fitting failures instead. The summer rainy season raises the water table, which can mask a small leak and make a moisture meter read wet everywhere, so we lean on pressure testing and acoustic listening rather than moisture alone. Florida Plumbing Code and St. Lucie County permitting apply to the repair, and we pull permits when the scope requires it. If you have been searching for under concrete slab leak detection Fort Pierce, the sequence is the same whether your home is on a raised slab or a mono-slab: isolate, listen, scan, confirm, mark. We also handle under foundation leak detection Fort Pierce FL calls where the water is entering at the slab edge rather than under the middle of the floor.
Lakewood Park
A mix of older block homes and newer builds, so we carry both copper and PEX repair materials on the truck for the same-day calls.
Downtown Fort Pierce
Historic homes with original copper lines and mature landscaping. Root intrusion and soil movement are common causes of under slab pipe leaks here.
Fort Pierce South
Newer PEX construction where fitting failures and manifold issues are more common than pipe corrosion. We check the manifold before opening the slab.
White City
Larger lots with longer service lines, so we isolate the yard line from the slab before assuming the leak is under the house.
Lawnwood
Older housing stock near the hospital corridor, with copper lines that often show pinhole corrosion after decades in local soil.
Sandy, shifting soil and a high water table
Soil movement cracks fittings and opens pinholes in copper, and the high water table can mask a small leak on a moisture meter. We rely on pressure testing and acoustic listening to confirm the location.
Summer rainy season saturation
From June through September, the ground stays wet and moisture readings become less reliable. Thermal imaging and tracer gas help confirm the break when the soil is saturated.
Older copper housing stock
Homes built before the 1980s are more likely to have copper pinholes, and multiple leaks in the same line may point to epoxy pipe lining instead of repeated spot repairs.
Most slab leaks announce themselves through the bill or the floor long before water reaches the surface. These are the calls we run most often in Fort Pierce, and each one has a specific detection approach.
Problem
A pinhole under a slab can waste hundreds of gallons a day, and the bill keeps climbing until the line is isolated and tested. Left alone, the water softens the soil under the slab.
Our Fix
We isolate the hot and cold sides with a pressure testing gauge, find which line is losing water, and pinpoint the break with acoustic and thermal tools. Most of these calls are resolved in a single visit.
Problem
A warm patch usually means a hot water line is leaking under the slab. The heat draws moisture up through the concrete and can warp vinyl or lift tile if it runs long enough.
Our Fix
A FLIR thermal imaging camera maps the temperature plume and narrows the break to a small area. We confirm with a moisture meter and mark the spot before quoting the repair.
Problem
Constant running water with everything shut off points to a pressurized line losing water under the slab or in the yard. Ignoring it runs up the bill and can undermine a foundation.
Our Fix
We pressure-test the system and use an acoustic listening disc to trace the sound to its source, whether that is under the slab or in the service line. You get a location, not a guess.
Problem
Soil movement from a long-running leak can shift the slab and crack tile or pull baseboards away from the wall. By the time cracks show, the leak has usually been active for weeks.
Our Fix
We combine moisture readings with thermal imaging to separate a plumbing leak from settlement, then locate the pipe break if one is present. If the issue is structural, we tell you and point you to the right trade.
A slab leak is not the expensive part. Cutting the wrong square of concrete is. Accurate detection turns a demolition project into a two-foot repair, and it protects the flooring, cabinets, and baseboards you already paid for.
Smaller, Cheaper Repairs
When we pinpoint a leak under concrete slab in Fort Pierce to within a few inches, the repair cut is typically 2 to 4 square feet instead of an entire room. That cuts concrete breaking, hauling, and patching costs, and it usually means one day of work instead of three.
Stop the Water Bill Bleed
A pinhole under a slab can waste 200 to 500 gallons a day, which shows up fast on a Fort Pierce utility bill. Finding the under slab water leak in Fort Pierce early stops the loss at the source and gives you a documented cause before the bill climbs another month.
Protect the Foundation
Water soaking into the soil under a slab softens the bearing surface and can lead to settlement cracks in the walls and floor. Catching an underground pipe leak early keeps the soil stable and avoids a foundation repair that costs many times what detection does.
No Guesswork, No Extra Holes
We use a pipe inspection camera and tracer gas detector to confirm the line and the break before anyone picks up a saw. You get a marked location, a written finding, and a repair plan, not a crew opening three holes hoping to get lucky.
Google ★★★★★4.9
They found a hot water line leak under our slab in about an hour and marked it within a few inches. The repair cut was small and the patch looks like it was never touched. Water bill is back to normal.
Yelp ★★★★★4.8
Called on a Saturday with water running under the floor. They answered, came out the same day, and pressure-tested the system before doing anything. Clear price, no upsell, and the leak was exactly where they marked it.
BBB ★★★★★4.9
We manage rentals near downtown and have used them three times for slab leaks. Every visit came with a written finding and photos for the owner. Professional crew and they show up when they say they will.
Pierce Leak Pros has been locating and repairing slab leaks in Fort Pierce since 2000, which is 26 years of working on the same soil, the same building codes, and the same housing stock. Our technicians hold Florida Licensed Plumbing Contractor and Florida Certified Plumbing Contractor credentials through the State of Florida DBPR, and we carry Backflow Prevention Certification and OSHA Safety Certification. We have pressure-tested thousands of slabs across St. Lucie County, from 1950s block homes near Downtown Fort Pierce to newer PEX builds in Fort Pierce South. That history is why we can usually tell you which line is failing before the camera comes out.
Real answers to the questions we hear most often from local homeowners and property managers.
Our core slab leak detection service covers the same pressure testing and acoustic work as under slab leak detection in Fort Pierce, with a focus on confirming whether the loss is under the slab or in the service line. We document the finding and quote the repair in the same visit.
View Slab Leak DetectionOnce we pinpoint the break, our slab leak repair crew cuts the marked area, replaces the failed section with copper or PEX, and pressure-tests before patching. Most residential repairs in Fort Pierce are completed in one day, including concrete patch and cleanup.
View Slab Leak RepairWater leak detection covers the whole system, including fixtures, irrigation, and the water heater, so we can rule out the easy causes before charging a slab. This is the service we run first when you are not sure where the water is going.
View Water Leak DetectionUnderground pipe leak detection handles lines outside the slab, including yard service lines and pool plumbing. If your meter runs with the house shut off, this service finds the buried break before it undermines a driveway or patio.
View Underground Pipe Leak DetectionFoundation leak detection focuses on water entering or moving under the structural slab, including cracks and settlement-related pipe damage. We combine moisture readings with thermal imaging to separate a plumbing leak from a drainage or waterproofing problem.
View Foundation Leak DetectionEmergency leak detection is for active water, a spike in the water bill, or a hot spot that appeared overnight. We keep a 24/7 line open and dispatch for under slab leak detection in Fort Pierce when the water cannot wait until morning.
View Emergency Leak DetectionIf you have water where it should not be, call us. We answer the phone 24/7, and most standard calls get same-day service. Tell us what you are seeing and we will tell you what it takes to find it. Serving Fort Pierce and all of St. Lucie County from ZIP 34950.
Phone
1234567890Address
3006 S US Hwy 1, Fort Pierce, FL 34982, USA
Hours
Mon–Fri: 7AM – 7PM
Sat: 8AM – 4PM
Sun: Emergency Only
24/7 Emergency Available